Brodit Aktive Halter Zebra TC215 zig.stecker - 3A boot

118,95 €

Auf Lager

Schneller Versand
Hochwertige Produkte
Sichere Zahlung

Details

Weitere Informationen

Compatibility

Anweisung

Details

Active holder with cig-plug

With tilt swivel. 3A charging. 12/24V. With Easy-switching system. Charging via pogo pins. Fits device with Zebra Original Rugged Boot.

The active holder charges your battery when it is in the holder. The charging device connects to the unit automatically when you put the unit in the holder. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Connects to the vehicle's cigarette lighter socket, 12/24 Volt.

Easy-switching system:

The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

Weitere Informationen

Weitere Informationen
Zubehörmarke	Brodit
Barcode	7320287123555
Empfohlener Verkaufspreis inkl. MwSt	118,95 €
Gerät mit oder ohne Hülle	miet Deckel
Haltereigenschaft	Toestelspecifiek
Cable / Qi / charger type / connnector	Molex, sig plug, piggy tail (Easy Switching)
Gerät laden über	Pogo / Pins
Stromspannung	12/24V
Voltage (output)	5.4V
Max Amperage	3,0 Amp
Montage standaard	AMPS
Halterschloss	nein
Color	zwart
Produktinformation	Professioneller Halter mit Drehgelenk für Ihr Smart Device. Störende Bildschirmreflexionen werden durch Einstellen des Halterungswinkels reduziert
Item Returns	This item can be returned

Mehr anzeigen + Zeige weniger -

Compatibility

Mehr anzeigen + Zeige weniger -

Anweisung

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.